Configure a Remote VTEP

Use the following procedure to configure the remote VTEP destination.

Procedure

  1. In the navigation pane, expand Configuration > Edit.
  2. Select VTEP.
  3. Select the Vtep tab.
  4. In Id, assign a unique index value to this remote VTEP.
  5. In IpAddr, enter the IP address of this remote VTEP.
  6. In Name, assign a name to this remote VTEP.
  7. Select Apply.

Vtep Field Descriptions

Use the data in the following table to use the Vtep tab.

Name

Description

Id

Specifies an index value in the range from 1 to 500 that uniquely identifies this remote VTEP.

IpAddr

Specifies an IP address that uniquely identifies this remote VTEP.

Note:

The remote VTEP IP address cannot be a local, broadcast, or multicast IP address.

Name

Assigns a name to this remote VTEP tunnel.

NextHopVrfName

Displays the VRF name of the next hop to reach the remote VTEP.

OvsdbConfigured

Specifies if the VTEP is configured with OVSDB protocol support for VXLAN Gateway.